![]() Use the function esp_deep_sleep_start() to enter the Deep Sleep mode. By default, the ESP32 turns off all peripherals that are not needed to detect the wake-up trigger. Optionally choose which peripherals you want to turn off or on during Deep Sleep mode, for example, which pins should remain on. There is no conflict between RTC io 16 and a reset button, both wired to reset pin. When you want to use the Deep Sleep mode, you have to think about :Ĭonfigure the type of wake-up source of the ESP32: The consumption of the ESP32 in the ♚ range will be slightly different from the chosen wake-up source. The only way to end the deep sleep of the esp8266 is a reset. ![]() Put the ESP32 in Deep Sleep mode with Arduino code So you can’t block the ESP32 with the Deep Sleep mode.įor more information about the ESP32 Deep Sleep, I encourage you to consult the official documentation on this subject. In this case, the ESP32 will be indefinitely in Deep Sleep mode until a manual reset is done by pressing the EN/RST button (or by reflashing the board). ![]() ![]() It is also possible to activate the Deep Sleep mode without configuring any wake-up sources.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |